-9-
Secure base to floor.
Securebaseto4'x4'x
3
⁄4" plywood.
Position the drill press in a sensible work
area where the base sits flat at all four
corners, or the base may crack when you
tighten the fasteners.
Mark and drill the floor, and install the
concreteanchorbolts(notincluded)(see
).
Position the base and fasten the base to
the floor carefully as not to crack it.
Center the drill press base along the back
edgeofthe4'x4'x
3
⁄4" sheet of plywood
(see).
Ateachcornerofthedrillpressbase,drill
the plywood.
Secure the base to the plywood with four
3/8"diameterbolts,washers,andnuts
(notincluded).
Position the base on a bench or tool table
capableofsupportingapproximately100
lbs.
Drilltwomountingholes(),and
secure the base to the table with the two
supplied carriage bolts and wing nuts
Place the column on the base, and install the
four column bolts supplied.
Formaximumstability,securetheW1670
floor-model drill press to a sturdy surface like
afloorora4'x4'x
3
⁄4" piece of plywood. For
theW1669bench-model,secureittoasturdy
workbench or tool table.
Workbenchmountingholes.
Mounting
Holes