Filter
Top Products
-8-
D3589 Mini Grinder Set
OPERATIONS
OPERATIONS
General
The Model D3589 will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous if performed incorrectly.
The instructions in this section are written with the under
-
standing that the operator has the necessary knowledge
and skills to operate this machine. If at any time you
are experiencing difficulties performing any operation,
stop using the tool!
If you are an inexperienced operator, we strongly recom
-
mend that you read books, trade articles, or seek training
from an experienced
person before performing any unfa-
miliar operations. Above all, your safety should come
first!
Always wear safety glasses when oper-
ating the mini grinder set. Failure to
comply may result in serious personal
injury.
READ and understand this entire instruc-
tion manual before using this machine.
Serious personal injury may occur if
safety and operational information is not
understood and followed. DO NOT risk
your safety by not reading!
Changing mini grinder accessories is easy. We recommend
that accessories such as polishing wheels, cutting wheels
and sanding drums/sleeves are installed before the acces
-
sory is installed on the mini grinder.
To change an accessory, do these steps:
1. UNPLUG THE MINI GRINDER!
2. Press in the chuck lock. If the chuck lock does not
engage, turn the chuck by hand until the chuck lock
engages. Loosen the chuck nut, as shown in
Figure
2.
3. Remove the chuck nut, collet, and any accessory
already installed on the mini grinder.
4. Select the collet size that fits the accessory you
wish to use, and install the collet on the mini
grinder.
5. Loosely screw on the chuck.
6. Fit the accessory shank into the collet, and slide it
into the collet until it stops.
7. Press in the chuck lock. Tighten the chuck.
Changing Accessories
Figure 2. Loosening the chuck nut.
Chuck Nut
Chuck Lock