Filter
Top Products
-3-
D4041 Miter Saw Stand Instructions
Adjusting Work Stand Extension Arms
1. Slide the extension arms out to their maximum reach
and place a straight 2x4 across the miter saw table
and rollers.
2. Loosen the crossbar knobs and rotate the roller
assemblies until the rollers almost touch the 2x4, as
shown in Figure 6. Then loosen the roller assembly
lock knobs, slide the rollers up to touch the 2x4, and
re-tighten the lock knobs.
7. Slide the roller assemblies into the crossbars and
secure them with the M8-1.25 x 20 knobs (see Figure
4).
8. Loosen the T-track lock knobs and adjust the T-tracks
to the width of your miter saw, then slide the heads
of two M8-1.25 x 50 hex bolts into each T-track.
9. Place the miter saw over the bolts, and secure each
location with one washer and two hex nuts (see
Figure 5); when securing these, tighten the top hex
nut against the bottom one so they do not work loose
from the vibrations that occur while cutting.
Folding Miter Saw Stand for Storage
1. Remove the support braces, retract the extension
arms and rotate the support rollers flat.
2. Push in the locking pins shown in Figure 7 and fold
the legs up into the stand.
Figure 6. Adjusting the support rollers.
Figure 5. Mounting the miter saw.
T-Track
Lock Knob
T-Track
Figure 7. Folding the miter saw stand.
Locking Pin