Filter
Top Products
-15-
SETUP
W1666, W1685 Dust Collectors
Figure 15. Separator in correct position.
Figure 16. Installing upper bag support.
Separator and Transfer
Hose
To install the separator and transfer hose, do these
steps:
1. The separator has three tabs with threaded holes
along
the bottom edge for mounting. Orient the sep-
arator so the holes align with supports and the inlet
is
pointed toward the separator body. See Figure
15.
2. Secure the front and back supports using the hex
bolts
and washers provided.
3. Secure the upper bag support rod and the last sepa-
rator support to the separator as in Figure
16.
4. Slide
a wire hose clamp onto the end of the transfer
hose.
5. Slide
the transfer hose end over the inlet for the
collector making sure the end passes the ridge on
the inlet by 1
1
⁄2".
6. Position
hose clamp over the hose and the inlet
making sure the clamp
is
3
⁄4" from the end of the
hose and tighten the screw on the clamp (see Figure
17).
7. Slide
the second hose clamp onto the free end of
the hose.
8. Slide the end
of the transfer hose onto the outlet of
the impeller housing. The hose should go on as far
as
possible.
9. Slide the hose
clamp within
3
⁄4" of the end of hose,
and tighten the screw on the clamp.
Never bypass the dust collector or and duct the transfer
hose outside without using dust collection bags, or move
the separator to a remote location and use a longer
transfer hose. Any modification can damage the dust
collector motor and create an unsafe condition.
Figure 17. Securing transfer hose with clamp.