Filter
Top Products
-10-
Figure 11. Correct rack orientation.
Figure 9.
Insert the pinion gear from the inside.
Figure 10.
Align setscrew with flat on pinion.
Table Support
1. Thread the 12mm table lock handle 3 turns
into the table support bracket.
2. Insert the pinion into the hole on the side of
the table support bracket from the inside,
starting with the pinion shaft.
Figure 9.
Align setscrew in crank handle with flat,
Figure 10,
on pinion shaft and secure using
the 3mm Allen
®
wrench provided.
3. Examine the rack and note that the gear
teeth extend further on one end than the
other.The shorter end must be positioned
down. Insert the rack into the table support
bracket and align with pocket. The end of
the rack where the gear teeth are closest to
the end should be positioned down as in
Figure 11.
The gear teeth on the rack must
also face out.
ASSEMBLY