Filter
Top Products
-26-
N(/()Fne\ijDXelXcD]^%j`eZ\*&'0
G8IKJ
Figure 36. Edge forming profile hazards.
Dflc[`e^;fjXe[;fekj
CORRECT
INCORRECT
CORRECT
Custom
3-Piece
Guide
Rail System
Mounted to
the
Sacrificial
Table
The Model W1812 will accommodate most moulding knife
profiles. However, you still must pay special attention to
workpiece support and knife-to-table clearance. Refer to
the following examples to avoid common workpiece setup
mistakes.
<[^\=fid`e^Be`]\:c\XiXeZ\
A wooden sacrificial table clamped to the cast iron table
and a three-piece guide system (Figure 36) will prevent
tool and table damage by absorbing the full sweep of the
knife.
Never attempt to use edge forming profile knives with-
out pre-installing a wooden sacrificial table. Often these
types of knives sweep lower than the workpiece and will
contact the table, causing severe machine damage or
personal injury.
Top View
REMEMBER, moulding knives have many different pro-
files, before starting the machine, always verify that
the moulding knives do not contact any part of the
workpiece guide rails, feed roller swing arm, or the
table surface.=X`cli\kfm\i`]pbe`]\Zc\XiXeZ\dXp
i\jlck`ej\m\i\`ealipXe[dXZ_`e\[XdX^\