Filter
Top Products
6
Kachinko System
7
Kachinko System
right (as you look from the front):
Operation
Locate the unit where the front light is clearly
visible by the camera.
• Make any necessary connections from the
TONE OUT to the camera, if you are not us-
ing the camera’s microphone.
• If you are recording the signal with the
camera microphone, set the POWER switch
to ON (BUZZ), otherwise set it to ON.
• Set the camera iris setting to manual. An
automatic setting can overcompensate for
the KS-1018’s lighting, and make it impos-
sible to see the “clapperboard” effect on
the target monitor.
• Make the image of the front light as large
as possible by putting the camera close in
front of the KS-1018. The focus of the cam-
era is not important in this case.
Set the MODE switch to AUTO. The main light
lights, and the beep sounds (or the signal is
output through the jacks). The three red LEDs