Filter
Top Products
-13-
be drilled is fairly large, drill a smaller hole first,
then enlarge to the required size, it’s often
faster in the long run. Main tain enough
pressure to assure that the bit does not just
spin in the hole. This will dull the bit and greatly
shorten its life.
Before using an accessory,
be certain that its maximum
safe operating speed is not exceeded by the
nameplate speed of the tool. Do not exceed
the recommended wheel diameter.
"%%$# $#
Variable speed control must be used with
caution for driving nuts and bolts with socket
set attach ments. The technique is to start
slowly, increasing speed as the nut or bolt runs
down. Set the nut or bolt snugly by slowing the
drill to a stop. If this procedure is not followed,
the tool will have a tendency to torque or twist
in your hands when the nut or bolt seats.
!
WARNING
#/<@3-/
%#"#"&
!"$##!</@/8>3@/
7+38>/8+8-/:/<09<7/.,C?8+?>29<3D/.
:/<=988/67+C</=?6>3873=:6+-38190
38>/<8+6A3</=+8.-97:98/8>=A23-2
-9?6.-+?=/=/<39?=2+D+<. We recom -
mend that all tool service be performed by a
Skil Factory Service Center or Authorized Skil
Service Station. SERVICE MEN: Disconnect
tool and/or charger from power source before
servicing.
$$"#
/+6/<>09<,+>>/<C:+-5=>2+>+</8/+<381
>2/3</8.90630/ If you notice decreased
tool performance or significantly shorter
running time between charges then it is time
to replace the battery pack. Failure to do so
can cause the tool to operate improperly or
damage the charger.
$ %"$
Your Skil tool has been properly lubricated
and is ready for use.
$ "#
The motor in your tool has been engineered
for many hours of dependable service. To
maintain peak efficiency of the motor, we
recommend it be examined every six months.
Only a genuine Skil replacement motor
specially designed for your tool should be
used.
6/+8381
$9 +@93. +--3./8>=
+6A+C=.3=-988/->>2/>996
+8.9<-2+<1/<0<97>2/:9A/<=?::6C
,/09</-6/+8381 The tool may be cleaned
most effectively with com pressed dry air.
6A+C= A/+< =+0/>C 19116/= A2/8
-6/+8381>996=A3>2-97:</==/.+3<
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through opening.
/<>+38-6/+8381+1/8>=
+8. =96@/8>= .+7+1/
:6+=>3-:+<>=Some of these are: gasoline,
car bon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
!
WARNING
+38>/8+8-/
!
WARNING
!
CAUTION
SM 1619X04037 01-10:SM 1619X04037 01-10 1/12/10 3:00 PM Page 13