Skil 3110 Saw User Manual


 
3.
!.*-*6-=6-.:;<*6-*4426;<:=,<276;/7:=;.7/'
.6,1 Failure to follow all instructions listed below may
result in serious personal injury.
#1.;<*58.-:*24;7:,4*58;5*A1*>.;1*:8.-0.;
Be careful in handling the bench to prevent being cut.
=44A*;;.5+4.*6-<201<.6*44<1./*;<.6.:;:.9=2:.-
/7:<12;;<*6- Also remember to occasionally check the
stand and make sure it is still tight. A loose stand is
unstable and may shift in use and cause serious injury.
./7:.78.:*<2605*3.;=:.<1..6<2:.=62<2;84*,.-
76*;742-/4*<4.>.4;=:/*,. Serious injury could occur
if tool is unstable and tips.
.>.:;<*6-76<*+4.7:=;.*;4*--.:7:;,*//74-260
Serious injury could occur if the table is tipped or the
cutting tool is accidentally contacted. Do not store
materials on or near the table such that it is necessary to
stand on the table to reach them.
767<47*-?2<157:.<1*64+; This table when
fully set and clamps are tightened is maximum rated to
220 lbs. Table could collapse under additional loads.
767<=;.*;;<7:*0.;1.4/ This table is not intended
to be a storage shelf.
767<;<7:.'.6,126-*5847,*<276;$;.764A26
-:A47,*<276; Humidity will cause the table top to distort
or the locks to become loose.
$;.764A"324:.84*,.5.6<8*:<; Any others may create
a hazard.
76C<=;.?2<1?7:382.,.;<1*<,*667<+.8:78.:4A
;.,=:.-<7<1.'.6,1
6;=:.?77-?7:382.,.2;8:78.:4A87;2<276.-+./7:.
cutting. Incorrectly positioned workpiece may cause you to
inadvertently cut into the X-Bench top, clamps or frame.
"8.,2/2,"*/.<A6;<:=,<276;/7:'.6,1
%"$"!"
Do not operate electric tools in gaseous or explosive at mo -
spheres. Motors in these tools normally spark, and may re -
sult in a dangerous condition.
##"&#!
Keep tools sharp and clean for better and safer perfor mance.
Follow instructions for lubricating and changing ac cessories.
Inspect tool cords periodically and if damaged, have repaired
by authorized service facility. Inspect ex tension cords
periodically and replace if damaged. Keep handles dry, clean
and free from oil and grease.
"75.-=;<,:.*<.-+A87?.:;*6-260
;*?2600:26-260-:244260*6-7<1.:
,76;<:=,<276*,<2>2<2.;,76<*26;,1.52,*4;367?6<7
,*=;.,*6,.:+2:<1-./.,<;7:7<1.::.8:7-=,<2>.1*:5
"75..@*584.;7/<1.;.,1.52,*4;*:.
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other masonry
products, and
• Arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies, depending on how often
you do this type of work. To reduce your exposure to these
chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are
specially designed to filter out microscopic particles.
This product contains a chemical known to the
State of California to cause cancer.
4*,.<1.?7:3260;<*6-76*;742-/4*<*6-4.>.4
;=:/*,.When the working stand can shift or rock, the
power tool or work piece cannot be steadily and safely
controlled.
767<7>.:47*-<1.?7:3260;<*6-7:=;.*;4*--.:7:
;,*//74-260 Overloading or standing on the working stand
cause the stand to be “top-heavy” and likely to tip over.
Use only Skil replacement parts. Any others may create a
hazard.
WARNING
!
WARNING
!
;;.5+4A#25.
The expected time to assemble and properly adjust this saw is two hours.