Filter
Top Products
-8-
In case of ground vibrations or position
changes during operation, the tool is
automatically leveled in again. To avoid
errors, check the position of the horizontal
and vertical laser line with regard to the
reference points upon re-leveling.
Operating Modes Fig.1
The tool has four operating modes between
which you can switch at any time with the
on/off switch 1:
–1 Horizontal laser line: The tool generates a
horizontal laser line running side to side.
–2 Vertical laser line: The tool generates a
vertical laser line running upward and
downward.
–3 Laser cross line: The tool generates two
laser lines one horizontal and one vertical
that cross. The laser lines cross each
other at a 90° angle.
–4 Manual Mode: The tool generates a
horizontal laser line with the compensator
locked. When the compensator is locked
the tool can be used on a tilt that
exceeds 4°.
–5 OFF:
LED indicator
A- LED Illuminates green when unit is ON
B- LED illuminates red in Manual Mode
C-LED illuminates red and lasers blink when
out of leveling range.
Working Advice
• Always use the center of the laser line
for marking. The width of the laser line
changes with the distance.
Working with the Tripod
A tripod offers a stable, height-adjustable
measuring support. Place the tool via the
tripod mount 5 onto the 1/4-20 male thread of
the tripod and screw the locking screw of the
tripod tight.
Use with Accessories