Filter
Top Products
-10-
For a straight 90° cut, use right side of notch
in the foot. For 45° & 51° bevel cuts, use the
left side (Fig. 8). The cutting guide notch will
give an approximate line of cut. Make sample
cuts in scrap lumber to verify actual line of cut.
This will be helpful because of the number of
different blade types and thicknesses
available. To ensure minimum splintering on
the good side of the material to be cut, face
the good side down.
"
"-*3 89&79.3, 9-* 9441
-41).9<.9-'49--&3)8
The torque from the motor can cause the tool
to twist.
To turn tool “ON”, squeeze the trigger switch.
To turn the tool “OFF”, release the trigger
switch, which is spring loaded and will return
to the off position automatically.
Your saw should be running at full speed
BEFORE starting the cut, and turned off only
AFTER completing the cut. To increase switch
life, do not turn switch on and off while cutting.
Always hold the saw handle with one hand
and the auxiliary handle or housing with the
other.
1<&>8'*8:7**.9-*7-&3)
)4*8349.39*7+*7*<.9-9-*
+7**24;*2*394+9-*14<*7,:&7)
Maintain a firm grip and operate the switch
with a decisive action. Never force the saw.
Use light and continuous pressure.
+9*7(4251*9.3,&(:9&3)
9-* 97.,,*7 -&8 '**3
7*1*&8*)'*&<&7*4+9-*3*(*88&7>9.2*.9
9&0*8+479-*'1&)*94(42*94&(4251*9*
8945):7.3,(4&89)4<34349&114<9-*
8&<94'7:8-&,&.389>4:71*,478.)*
8.3(*9-*14<*7,:&7).87*97&(9&'1*.9
(4:1)(&9(-43>4:7(149-.3,&3)*=548*
9-*'1&)**&<&7*4+9-*3*(*88&7>'1&)*
*=548:7*89-&9*=.89.3'49-9-*:55*7&3)
14<*7,:&7)&7*&8
When cutting is interrupted, to resume cutting:
squeeze the trigger and allow the blade to
reach full speed, re-enter the cut slowly and
resume cutting.
When cutting across the grain, the fibers of
the wood have a ten den cy to tear and lift.
Advancing the saw slowly minimizes this
effect. For a finished cut, a cross cut blade or
miter blade is rec om mended.
$
This tool is not designed for use with metal or
masonry cut-off wheels.
4349:8*&'7&8.;*<-**18
<.9-(.7(:1&78&<8'7&8.;*
):892&>(&:8*14<*7,:&7)94+&.1
45º 0º
FIG. 8
45° & 51°
BEVEL CUTS
90°
VERTICAL
CUTS
!
WARNING
!
WARNING
!
WARNING
!
WARNING
SM 1619X03982 09-09:SM 1619X03982 09-09 9/8/09 2:18 PM Page 10