Filter
Top Products
-68-
For Machines Mfg. Since 7/09
EVS Toolroom Lathes
SERVICE
Feedrod Clutch
Adjustment
This lathe has an adjustable feed clutch that
helps protect the drivetrain from overload.
The feed clutch release point is adjusted at
the factory. However, it can be easily adjusted
depending on operator requirements.
Tools Needed: Qty
Phillips Screwdriver #2 ........................................1
Hex Wrench 3mm .................................................1
To adjust the clutch release point:
1. DISCONNECT LATHE FROM POWER!
2. Remove the front and side feed access covers,
as shown in Figure 133.
5. Line up the set screw hole in the clutch
collar with the closest set screw slot that is
cut into the feedrod (see Figure 135).
6. Install and tighten the set screw so it is fully
seated in the slot.
7. Re-install both access covers.
Set Screw
Slot
Collar
Adjustment Hole
Figure 135. Feed clutch set screw alignment.
4. Insert the hex wrench into the collar
adjustment hole shown in Figure 135, and
use the wrench to rotate the clutch collar.
— If you need to increase the release point,
rotate the clutch collar upward.
— If you need to decrease the release point,
rotate the clutch collar downward.
3. Remove the clutch collar set screw, as shown
in Figure 134.
Figure 134. Removing set screw from clutch collar.
Figure 133. Feed access covers removed.
Feed Access Cover