Filter
Top Products
Instruction Sheet
PHONE: (360) 734-1540 • www.southbendlathe.com
MODEL SB1044
CUTTING FLUID KIT
Specifications
• Motor .......................................................
1
⁄8 HP
• Phase & Cycle .................3-Phase & 50/60 Hz
• Voltage ............................................220V/440V
• Current ..................................... 0.3/0.15 Amps
• Pump Type ..................................................Jet
• Pump Flow ........................................ 8.2 GPM
• Cutting Fluid Type .........Water-Soluble Only
• Maximum Tank Capacity ......................9 Gal.
• Net Weight .............................................73 lbs
• Country of Origin ................................ Taiwan
BIOLOGICAL & POISON
HAZARD!
Use the correct personal
protection equipment
when handling cutting
fluid. Follow federal, state,
and fluid manufacturer
requirements for proper
disposal.
Introduction
This cutting fluid kit is for the Model SB1029
Surface Grinding Machine. The system is
designed to pump water-soluble cutting fluid to
minimize grinding wheel wear, load-up, glazing,
and heat. Using cutting fluid helps maximize
the quality of workpiece results, especially on
materials that should not be ground dry.
Figure 1. Model SB1044.
Unpacking
This item was carefully packaged to prevent
damage during transport. If you discover any
damage, please immediately call Customer
Service at (360) 734-1540 for advice. You may
need to file a freight claim, so save the containers
and all packing materials for possible inspection
by the carrier or its agent.
Inventory
Item: Qty
• Tank Assembly w/Pump ................................1
—Drain Hose 1
3
⁄4" x 5' ....................................1
—Hose Clamp 1
3
⁄4" ........................................1
—Delivery Hose
1
⁄2'' x 9' .................................1
—Hose Clamp 1
3
⁄4'' .........................................1
—Flex Conduit Power Cord 9' .......................1
—Drain Adapter .............................................1
—Swivel Caster Wheels .................................4
• Splash Guard .................................................1
—Button Head Cap Screw M6-1 x 10 ...........4
—Front & Rear Splash Panel .................. 1 Ea
• Coolant Trough ..............................................1
Copyright © December, 2010 by South Bend Lathe Co.
WARNING: No portion of this manual may be reproduced without written approval.
#CR13482 Printed in Taiwan
If you need help with your new model
SB1044 Cutting Fluid Kit, contact us at:
PHONE: (360) 734-1540
FAX: (360) 676-1075
EMAIL: sales@southbendlathe.com