Filter
Top Products
ASSEMBLY INSTRUCTIONS
6
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part please
call our toll-free number for assistance 1 (800) 375-7520 or e-mail us at:
parts@staminaproducts.com
STEP 1
Lift up the LEFT and RIGHT PEDAL ARMS(2, 3). Insert the PULLEY BRACKET(7) into the Collar on the
MAIN FRAME(1). Wrap the CABLE(9) around the PULLEY(8) and press the two PEDAL ARMS(2, 3)
down. Refer to illustration A.
NOTE:
COLLAR
A.
B.
Ring
1. Please be careful not to damage the SENSOR WIRE(11) when attaching the METER(13).
2. See page 8 for detailed battery installation instructions.
STEP 2
Refer to illustration B. Hook the RESISTANCE TUBES(32) onto the Rings in the LEFT and RIGHT PEDAL
ARMS(2, 3).
Install one AAA battery into the back of the METER(13), one battery included. Plug the SENSOR WIRE(11)
into the METER(13), then slide the METER(13) onto the MOUNTING CAP(12).
NOTE:
Always make sure that the CABLE(9) is properly seated in the groove on the PULLEY(8) before
using the INSTRIDE
PLUS stepper.