Filter
Top Products
DIRECTIONAL EXHAUST DEFLECTOR
Disconnect air supply. Rotate exhaust deflector to desired position.
Reconnect air supply.
-
11-
ACCESSORIES AVAILABLE
BC601 4 oz. Bostitch Air -Tool Lubricant
BC602 1 pint Bostitch Air -Tool Lubricant
BC603 1 pint Bostitch “Winter-Formula” Air-Tool Lubricant
BC604 1 quart Bostitch Air -Tool Lubricant
100679 Lube, (1lb. can)
851325 LOCTITE Grade 271 (.02 oz.)
851385 LOCTITE Grade 242 (.02 oz.)
108550 Vinyl Siding Trip 438/538
106427 Wrench, Sleeve Cap
108212 Kit, Long Magazine 400/500 S2
108213 Kit, Long Magazine 400/500 S4
108214 Kit, Long Magazine 400/500 S5
112603 Weight Cap - 538 Series
112604 Weight Cap - 438 & 450 Series
CNTK2 Kit, Contact Trip Conversion (Black Trigger)
TVA12 Trigger Valve Assembly
RECOMMENDED TOOLS
1 8mm Nut Driver
1 5mm Hex Wrench
1 4mm Hex Wrench
1 3mm Hex Wrench
1 2.77mm (.109”) diameter Pin Punch
1 5.56mm (.219”) diameter Pin Punch
1 Hammer
1 Small Straight Blade Screw Driver
QUICK RELEASE MAGAZINE
The 400 & 500 series staplers contain a Quick Release Magazine feature. The magazine is spring loaded
to reduce jamming. When a jam does occur, a quick release mechanism at the rear of the magazine allows
the magazine to move back, in order to clear the jam.
ALWAYS DISCONNECT AIR SUPPLY BEFORE CLEARING A JAMMED FASTENER.
If a jam does occur, locate the latch at the rear of the magazine (fig.1). Pull down on the latch to open
(fig.2), and rotate it clockwise 1/4 turn (fig.3). Pull back on the latch (fig.4). This will pull the magazine back
to clear the jam. After removing the jammed fastener, push on the latch, rotate it 1/4 turn counterclockwise
and push up to close.
FIG.3
FIG.2
FIG.1
FIG.4
LATCH
O
P
E
N
ROTATE
PULL
Exhaust
Deflector