Filter
Top Products
11
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This Class B
digital apparatus complies with Canadian ICES-003.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our service
website at www.bostitch.com. You can also order parts from your nearest Bostitch
Factory Service Center or Bostitch Authorized Warranty Service Center. Or, you can call
our Customer Care Center at (800) 262 2161.
TROUBLESHOOTING
Problem Possible Cause Possible Solution
• Unit will not start. • Battery pack not installed • Check battery pack
properly. installation.
• Battery pack not charged. • Check battery pack charging
requirements.
• Battery pack will not • Battery pack not inserted into • Insert battery pack into
charge. charger. charger until green LED appears.
• Charger not plugged in. • Plug charger into a working
outlet. Refer to “Important Charging
Notes” for more details.
• Surrounding air temperature • Move charger and battery
too hot or too cold. pack to a surrounding air temperature of
above 40 degrees F (4.5°C) or below
105 degrees F (+40.5°C).
• Unit shuts off abruptly. • Battery pack has reached its • Allow battery pack to cool
maximum thermal limit. down.
• Out of charge. ( To • Place on charger and
maximize the life of the allow to charge.
battery pack it is designed
to shutoff abruptly when
the charge is depleted.)
For assistance with your product, visit our website at www.bostitch.com for a list of service
centers, or call the Bostitch Customer Care Center at (800) 262 2161.