Bostitch BTE100K Drill User Manual


  Open as PDF
of 28
 
5
FUNCTIONAL DESCRIPTION
Figure A
1. Variable speed switch
2.Lock-onbutton
3.Reversinglever
4.Keylesschuck
5.Beltclip
B
c
d
1
1
4
a
5
2
3
3
SAFETY WARNINGS AND INSTRUCTIONS: DRILLS
WARNING: Drillmaystall(ifoverloadedorimproperlyused)causingatwist.Always
expectthestall.Gripthedrillfirmlywithbothhandstocontrolthetwistingactionand
preventlossofcontrolwhichcouldcausepersonalinjury.Ifastalldoesoccur,releasethe
triggerimmediatelyanddeterminethereasonforthestallbeforere-starting.
ASSEMBLY
WARNING:Toreducetheriskofinjury,beforeassembly,makesurethatthetoolis
switched off and unplugged.
INSERTING A DRILL BIT OR OTHER ACCESSORY (FIGURE B)
WARNING: Do not attempt to tighten drill bits (or any other accessory) by
gripping the front part of the chuck and turning the tool on. Damage to the chuck and
personal injury may occur when changing accessories.
WARNING: Always ensure the bit is secure before starting the tool. A loose bit
may eject from tool causing possible personal injury.
Yourtoolfeaturesakeylesschuck(4)forgreaterconvenience.Toinsertadrillbitor
otheraccessory,followthestepslistedbelow.
• Grasptherearhalfofthechuckwithonehandanduseyourotherhandtorotatethe
fronthalfcounterclockwise,asshowninfigure B.Rotatefarenoughsothatthechuck
opens sufficiently to accept the desired accessory.
• Insertthebitorotheraccessoryabout3/4inch(19mm)intothechuckandtighten
securelybyholdingtherearhalfofthechuckandrotatingthefrontportioninthe
clockwisedirection.
• Toreleasetheaccessory,repeatstep1listedabove.
 previous next