Filter
Top Products
-2-
SAFETY INSTRUCTIONS
EYE PROTECTION
which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when connecting to air supply, loading, operating or servicing this
tool. Eye protection is required to guard against flying fasteners and debris, which could
cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
CAUTION:
Additional Safety Protection will be required in some environments. For
example, the working area may include exposure to noise level which can lead to hearing
damage. The employer and user must ensure that any necessary hearing protection is
provided and used by the operator and others in the work area. Some environments will
require the use of head protection equipment. When required, the employer and user must
ensure that head protection conforming to ANSI Z89.1 is used.
Your D61ADCSB Side Strike Stapler is
shipped from factory completely assembled
and ready for use. Before operation, read the
provided Operation and Maintenance Manual
for the D61ADC Carton Closer, which is a part
of this machine. Follow the Operation and Air
Supply instructions carefully – note all the
Warnings and Cautions.
Please also note that the instructions in the
D61ADC manual for loading the magazine do
not apply in this case. The coil of staples are to
be mounted on the short piece of plastic tube
cradled above the tool. All other instructions in
the D61ADC manual apply.
After extensive use of the D61ADCSB, or
when exchanging the D61ADC staples, it may
be necessary to adjust either the trip foot or
the trip cylinder.
To prevent accidental
cycling, always disconnect the air supply
before making adjustments, servicing the
machine, clearing jams and when the
machine is not in use.
1. T
o Adjust the Trip Foot:
Disconnect the air supply. Loosen the two Trip
Foot mounting holes. The Trip Foot may be
moved on its slotted holes. Adjust so that the
Trip foot comes up flush against the bottom of
the D61ADC when the Valve is fully actuated.
The Trip foot and the Valve should bottom out
together.
2. To Adjust the Air Cylinder:
Make sure air supply is disconnected. With the
D61ADC Trigger held closed, there should be
a minimum clearance between the Trigger and
the Actuating Rod when the Rod is pushed
toward the Trigger to the end of the Air
Cylinder stroke. Adjust the clearance by
loosening the two nuts that hold the Air
Cylinder in the frame, and repositioning the Air
Cylinder and retightening the nuts. If the
Cylinder is being replaced, adjust the Air
Cylinder in the frame.
Note: For best performance, the Depth
Adjustment on the D61ADC should be at a
high setting. At too low of an adjustment,
the driver will push the box away from the
D61ADCSB. The Front Adjustment Plate
of the D61ADC should be set at
approximately the number 3 setting; see
“Depth Adjustment” paragraph in the
D61ADC manual.
To prevent accidental
injury, never place hands or any other part
of the body in contact with the actuating
arm or in the staple clinching area.
Lubrication:
The D61ADCSB Side Strike Stapler should not
require lubrication other than the application of
a light machine oil to the pivot points two to
three times a year.
Refer to the Operation and Maintenance
Manual for the D61ADC for proper lubrication
of the tool.