Filter
Top Products
-6-
1. Open the magazine: pull down down latch and swing door open. Swing magazine cover open.
2. Check adjustment: the nailer must be set for the length of nail to be used. Nails will not feed
smoothly if the magazine is not correctly adjusted. To change setting:
a) Release the canister latch on the rear of the canister.
b) Pull out canister bottom by swinging right to left until tabs disengage.
c) Inside the canister bracket are settings in inches and millimeters. The canister is adjusted
correctly when the length of the nail being used is shown in the window of the canister bottom.
Canister
cover
Canister
latch
Canister
bracket
Canister
bottom
Feed pawl
Door
3. Load the coil of nails:
Place a coil of nails over the post in the canister. Uncoil
enough nails to reach the feed pawl, and place the second
nail between the teeth on the feed pawl. The nail heads fit in
slot on nose.
4. Swing cover closed.
5. Close the door.
Check that latch engages. (If it does not engage, check that
the nail heads are in the slot on the nose).
Note: The canister is adjusted correctly for 1-1/2” nails when
“1-3/4 (45)” appears in the window of the canister bottom.
NOTE: Use only nails recommended by Bostitch for use in Bostitch N100C/N100CPP/N130C Series
nailers or nails which meet Bostitch specifications.
Canister
bracket
Window
Canister
bottom
IN
.
1 3/4
2
2 1/4
2 1/2
2 3/4
3
3 1/4
MM
(45)
(50)
(57)
(65)
(70)
(75)
(83)
LOADING THE N100C/N100CPP/N130C SERIES COIL NAILER
EYE PROTECTION
which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator
and others in the work area when connecting to air supply, loading, operating or servicing
this tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
•Never place a hand or any other part of the body in nail discharge area of tool while
the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
•Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.