Filter
Top Products
-11-
RN45B DRIVER MAINTENANCE INSTRUCTIONS
Worn driver causing poor quality or loss of power:
-Wear on the driving tip will affect the nail drive, giving symptoms of bent and incompletely driven
nails, and damaged nail heads.
-The driver length may be adjusted to allow the driving tip to be redressed to compensate for wear.
Heat and precise measurement are required. Contact a qualified service technician for this
adjustment.
-The length setting for a new driver is shown below. Measurement is from the bottom face of
the main piston.
-Note that the measurement from the top of the piston gives the maximum amount the driver may be
adjusted to allow redressing. Always extend the driver the minimum required to allow redressing to
restore the driving end; several redressings will be possible before this maximum depth is reached.
DIRECTIONAL EXHAUST DEFLECTOR
Loosen screw as shown. Adjust to desired exhaust direction and tighten screw.
ACCESSORIES AVAILABLE
BC601 4 oz. Bostitch Air-Tool Lubricant
BC602 1 pint Bostitch Air-Tool Lubricant
BC603 1 pint Bostitch "Winter-Formula" Air-Tool Lubricant
BC604 1 quart Bostitch Air-Tool Lubricant
100679 O-Ring Lube 1 lb. can
SEQ5 Sequential Trip Conversion Kit
VSA2 Vinyl Siding Kit
DC6 Depth Control Kit
851325 Loctite® 271 Packet
ORK13 O-Ring Kit
BK11 Bumper Kit
FPK1 Frame Protector Kit
CNTK2 Contact Trip Conversion Kit (black trigger)
TVA6 Trigger Valve Assembly
4.675” - 4.685”
(118.7mm - 119.0mm)
5/32” (4.0mm) maximum limit of driver recessed into piston.
Do not exceed this limit.