Filter
Top Products
10. Tighten each set of the knife bolts; making sure that the knife is
seated against the back heel in the rotor seat. Before torquing
the bolts, check that a 0.001” feeler gage cannot fit between the
heel and the back of the knife.
11. Torque the rotor knife bolts to 100 Lbs./ft. (14 Kgm, 135 Nm).
12. Adjust the knife gap with the bed knives and close the
machine, following Steps 8-14 in Section 6-4.
6-7 Specifications for Re-sharpening Bed Knives
Every bed knife has two cutting edges, one on each side. When a
blade becomes worn, the knives can be rotated. To regrind these
knives, refer to the data shown in Figure 14. Replacement of these
knives is necessary when their length falls below the recommended
tolerance.
Page 39 of 54