Filter
Top Products
PAGE 28 — STOW CUTTER 1 CE — OPERATION MANUAL — REV. #2 (12/20/07)
STOW CUTTER 1 CE SAW — OPTIONAL WATER TANK
9 Place the Water Tank (with the hose assembled), onto the
Tank Shelf so the valve and hose are resting in the notch of
the top of the Tank Shelf. (Figure 26)
10. Place the Bungee Cord (item 4) over the Water Tank (item 14)
so it securely holds the tank onto the Shelf.
11. Disconnect the existing water hose from the saw blade guard
and connect instead, the new hose using the Swivel Connec-
tor. (item 5)
Remove the pre-existing water hose entirely or fasten it away
from any contact or interference with the blade or any moving
part.
CAUTION
Figure 26. Water Tank Position
14
5
4
Decommissioning Saw/Components
Decommissioning is a controlled process used to safely retire a
piece of equipment that is no longer serviceable. If the equipment
poses an
unacceptable and unrepairable safety risk due to wear
or damage or is no longer cost effective to maintain, (beyond life-
cycle reliability) and is to be decommissioned,
(demolition and
dismantlement), the following procedure must take place:
1. Drain all fluids completely. These may include oil, gasoline,
hydraulic oil and antifreeze. Dispose of properly in accor-
dance with local and governmental regulations. Never pour
on ground or dump down drains or
sewers.
2. The remainder can be brought to a salvage yard or metal
reclamation facility for further dismantling.