Filter
Top Products
STUDER INNOTEC HP-COMPACT
HP-COMPACT V5.4 22/80
− Over temperature (LED 10 lit)
− Overload (LED 11 lit)
− Over or less voltage of batteries (LED 12 lit or blinking)
− HP-COMPACT is turned off manually or with a fault (LED 13 lit)
In case this function is not wished, it must be modified by programming according to
procedure in chap. 5.4.
4.9 The Remote Control RCC-01
As an option, a Remote Control
can be connected to the HP-
COMPACT. All operating
controls and displays except
from level adjustment are
available on the Remote
Control. The Remote Control is
supplied with a 20m long cable.
It can as long as 40m. The
Remote Control is suitable for
surface mounting on the wall or
on to a switch board. It is fixed
with 4 screws. The HP-
COMPACT can also be
programmed with the Remote
Control. The Programming is
described in the section
„Programming“.
The output power and the charging currents are displayed on the Remote Control.
In the Remote Control there is an additional Alarm Contact and a built-in Control
Input. These two functions are available through Tip-jack RJ11/4 for use. This
Auxiliary Contact is Front / Work Contact (max. 0.5A!), which is independent from the
Auxiliary Contact of the HP-
COMPACT. This contact is
active in case of an alarm of the
HP-COMPACT.
The Control Input is connected
in parallel to the ON/OFF- push
button. The HP-COMPACT can
be switched on or off through
this input with an impulse button
or an impulse contact.
Caution: No external voltage
should be connected to this
Input Control.
Order Number for Remote Control: RCC-01
Dimensions: H x B x T / 111.5 x 136.5 x 25mm
4.10 The Temperature sensor CT-35
Operating voltage of lead-acid batteries change depends on the
temperature. To correct the operating voltages according to the