Filter
Top Products
www.tanaka-usa.com
6 contacttanaka@tanaka-ism.com
Owner’s Manual
TED-210/TED-262L/R/DH/HS
Drilling (Fig. 2-5,5B)
•
Always hold unit firmly with both hands on handles and body well balanced.
•
Operate at a high engine speed and let the drill bit do the work. Do not force bit into the hole.
•
If materials become twisted around drill bit, stop engine, allow unit to cool and remove wire from spark
plug before attempting to clear bit.
•
Stop engine and inspect unit if abnormal vibration or noise is generated.
How to operate Lock control (on TED-262L/262DH) (Fig. 2-5C)
NOTE! Always stop the engine before operation of lock control.
•
When bit has stuck in object, stop engine and turn on lock lever (1).
•
Rotate whole unit counter-clockwise so that the bit can be pulled out easily.
•
If the unit would not move, rotate it clockwise a little and then counter-clockwise again.
How to operate Reverse control (on TED-262R) (Fig. 2-5D)
•
Decrease engine speed to idle and move shift lever (2) to R (Reverse) position, then accelerate to pull out.
•
Shift lever may not move unless engine is running. If so, turn drill chuck a little bit by hand.
•
The purpose of Lock control and Reverse control is mainly for easy removal of bit.