Filter
Top Products
12V, 14.4V, 18V
Cordless Drills
Owner’s Manual
5. To reduce the risk of damaging the battery charger power cord, be sure to pull
the plug rather then the cord when disconnecting it from the power supply.
Always position the cord so it will not be stepped on or tripped over. This will
prevent damage to the cord.
6. An extension cord should not be used unless absolutely necessary. Use of an
improper extension cord can result in risk of fire or electric shock. If using an
extension cord make sure that:
A) The pins on the plug of the extension cord are the same number,
size and shape as those on the plug on the charger.
B) The extension cord is properly wired and in good working
condition.
C) The wire size is the same or larger than the ones specified below:
Recommended size of Extension Cord for Battery Charger
Length of Cord (Feet) 25 50 100 150
AWG Size of Cord* 18 18 16 14
* The smaller the AWG (American Wire Gauge) number of the extension cord,
the higher the capacity of the cable for conducting current to ensure proper
usage of the tool.
7. Do not operate charger with a damaged cord or plug.
8. Do not operate the charger if it has received a sharp blow, been dropped or
damaged in any other way.
9. Do not open the drill, battery or battery charger. There are no user serviceable
parts. Opening the unit will void the warranty.
10. Unplug the charger from its power source when not in use.
11. Do not touch the terminals inside the battery charger with any other metal
object such as nails or coins. This can short the charger.
12. Do not store the unit in areas where the temperature can exceed 120°F.
13. Do not throw the battery or battery charger in fire. This can cause an
explosion.
14. During extreme conditions, the battery may leak. This does not indicate a
battery failure. However, if the liquid gets on your skin, immediately wash
with soap and water, neutralize the area with a mild acid such as lemon juice
or vinegar. If the liquid gets into your eyes, flush them with clean water
immediately for a minimum of 10 minutes and seek medical attention.
Controls and Components:
Batteries and AC Charger
1. Battery with Release Buttons On Each Side (PMD8133 includes 2 batteries)
2. 120V AC Adaptor
3. Charging Stand with LED Charging Indicators
Drill:
4. 3/8” Jacobs Keyless Chuck
5. 24 Adjustable Torque Settings Control Ring
6. Forward/Lock/Reverse Switch
7. High/Low Speed Switch (PMD8131 and PMD8133 only)
8. Variable Speed Trigger Switch
9. Accessory/Bit Holder
10. Comfort Rubber Grip (PMD8131 and PMD8133 only)
Accessories:
11. 6 Various Screwdriver Bits
12. 2” Extension Bar
13. 2 Double Ended Screwdriver Bits
14. 6 Various Drill Bits
(Each Drill comes with a storage case.)
3 4
1
2
3
4
5
6
7
8
9
10
11
12
13
14