Filter
Top Products
5. I followed the Quick Installation Guide and setup a new password. When I log
in to the browser configuration an access error message appears. What should I
do?
If the password was changed and you don't remember it, you need to reset the
TEW-637AP. To reset the TEW-637AP, power up the unit and wait 30 seconds for
the unit to boot up. Then take a pin or paper clip and press the reset button for 15
seconds, then let go. The reset button is located on the bottom of the TEW-637AP.
Please note that performing a reset on the TEW-637AP will erase all settings
applied and will revert back to default settings. The default user name is admin
and the default password is admin. When you log in to the browser configuration
for the first time, make sure to enter admin for user name. Do not leave the user
name field blank
8
If you still encounter problems or have any questions regarding the TEW-637AP, please
contact TRENDnet's Technical Support Department.
LED/Button
PWR (Power) LED
Green Solid
Network Port
Link/Act LEDs
N/A Off
Green
Solid
Wireless LED
Blinking
WPS LED
N/A
Power Switch
(EU Version only)
Reset Button
Off
WPS Button
Green
N/A
Green
N/A
N/A
Blinking
N/A
Off
Solid
N/A
Blinking
Off
N/A
N/A
N/A
Color Sequence Definition
Device is on
LAN port connected at 10/20 Mbps or 100/200Mbps
(Half/Full Duplex)
Wireless LAN is on or enabled/Wireless data transmission
Wireless LAN is on or enabled/Wireless data transmission
WPS authentication process complete
WPS is not activated or disabled
Turns on/off power to the TEW-637AP
Hold 15 seconds to reset device to factory defaults.
Hold 3 seconds to activate WPS
Device is off
LAN port data transmitting/receiving 10/20Mbps
or 100/200Mbps (Half/Full Duplex)
Wireless LAN is off or disabled
WPS authentication in process