Filter
Top Products
Q1:
A1:
Q2:
A2:
Q3:
A3:
Q4:
A4:
Q5:
A5:
After connecting the TPE-224WS to a power outlet, the LEDs do not turn on.
Check the connection of the power cord to the TPE-224WS and the power outlet. Also
check that the power outlet is receiving power.
After installing the Web-Management Utility, I clicked Discovery and the Utility is unable to
discover the TPE-224WS. What should I do?
Make sure that the TPE-224WS is powered on and that all connections are secure. Also
check that your computer's IP Address is on the same network segment as the TPE-224WS.
The default IP Address of the TPE-224WS is and the default password is
"admin".
When I access the TPE-224WS using a web browser, I get a screen that tells me “only one
user can login”. What should I do?
Another computer is configuring the TPE-224WS. Please wait until the user logs off. If the
other user has already logged off and you still get the same screen, then disconnect the power
cord from the TPE-224WS, wait for 5 seconds, reconnect the power cord to the TPE-224WS,
allow 5 seconds for the switch to power on, and then attempt to access the web configuration
page to login.
When I connect a computer to the switch's port, the LINK/ACT LED turns on, but the
100Mbps LED remains off.
When the 100Mbps LED remains off, the computer's connection speed is 10Mbps.
I connected a Power-over-Ethernet (PoE) device into the switch's PoE port, but the PoE
Status LED remains off.
Check the connections between the PoE port and the PoE device. Make sure that the
CAT-5 cable is properly inserted into the PoE port and PoE device.
If you still encounter problems or have any questions regarding the TPE-224WS, please refer to the
User's Guide included on the Utility CD-ROM or contact Trendnet's Technical Support Department.
http://192.168.0.1
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may cause
undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
6
Troubleshooting
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.