Vector SLH100P Work Light User Manual


 
7
3. Disconnect the terminals and replace the battery with the same type and size
listed in the Specifications section in the back of this manual.
4. Replace the battery compartment cover and screws.
5. Turn the spotlight’s ON/OFF switch to the ON position to ensure proper
operation of spotlight.
Safe Battery Disposal
Contains a maintenance-free, sealed, non-spillable, lead acid battery,
which must be disposed of properly. Recycling is required, contact your
local authority for information. Failure to comply with local, state and
federal regulations can result in fines, or imprisonment. For more
information on recycling this battery, call toll-free (877) 288-7722.
TROUBLESHOOTING
Problem Possible Cause Possible solution
• Lamp is still hot HID lamp power was HID lamp can take up to 10
and will not restart suddenly interrupted. minutes to reach full light power
immediately. after a power interruption.
Lamp will not power. Internal battery needs Check battery level and recharge
charging. unit if necessary using AC or DC
charging adapters. If battery
does not take a charge, it needs
to be replaced. Contact an
authorized service center.
Power switch is OFF. Turn the power switch to the ON
position.
Unit is still charging. Disconnect recharging adapters
from unit and power source and
wait five minutes before using.
• Unit will not recharge.
DC plug is not Be sure to properly make a good
connected to the connection to vehicle’s accessory
vehicle. outlet before recharging the unit.
DC plug damage Have cord replaced by an
authorized service center.
120 VAC charging Connect 120 VAC wall cube
adapter is not adapter’s barrel connector to
connected to the unit’s recharging port and then
charging port to 120 VAC wall receptacle.
There is no power 120 volt wall receptacle circuit
after conncecting tripped and needs to be reset.
to 120 volt wall If problem continues, servicing
receptacle receptacle is advised.
SLH100P_ManualEN_091406 9/28/06 10:55 AM Page 7