Filter
Top Products
10. Insert the replacement bulb into the reflector's flange.
11. Put back and secure the hairpin retaining wires.
12. Connect the white bulb power wire to the red power wire.
13. Tighten the retaining screw on the flange.
14. Place the reflector in position in the body of the spotlight.
15. Replace the rubber "O" ring in the groove around the perimeter of the reflector.
16. Replace glass and retaining ring so that the screw holes are aligned.
17. Secure retaining ring with two Phillips screws.
18. Replace rubber bezel by sliding forward to the front of the spotlight.
19. Operate switch to ensure proper operation of spotlight.
7
FIGURE 3A
FIGURE 3B
Open
Closed
Open
Closed
RUBBER BEZEL
RETAINING RING
REFLECTOR ASSEMBLY
PHILLIPS SCREW
SCREW
HAIRPIN RETAINING
WIRES
RUBBER”O” RING
GLASS LENS