Filter
Top Products
10
Approximate continuous runtimes on a fully charged battery are:
Spotlight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.5 hours
Fluorescent light . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 hours
Emergency flasher . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150 hours
Recharge the battery pack after each use. Refer to Section 5 for details.
8.1 PARTS REPLACEMENT LANTERN LIGHT
Replaceable parts for the lantern light are:
The quartz halogen bulb; the fluorescent tube, and the battery pack.
FIGURE 6 - LANTERN LIGHT PARTS REPLACEMENT
8.2 QUARTZ HALOGEN BULB REPLACEMENT
The bulb is a 15 watt, 12 volt G4 projection type. This type bulb has two connector
pins that plug into a socket. The procedure follows:
1. Unscrew the bezel (counterclockwise) and remove the bezel and lens.
2.
Hold the reflector in place against the body of the lamp and pull the bulb straight out.
Note the location of two socket holes that accept the bulb pins.
3. Unpack the new bulb. Using a clean cloth, remove it from the packing material.
NOTE: Do not touch the new bulb with bare hands; oil from fingers can cause
premature failure of these bulbs. If the bulb is touched, clean the bulb with alcohol on
a clean cloth after the bulb is installed.
9
8. LANTERN LIGHT
The lantern light comprises three lights in one. The spotlight provides a bright focused
light. A bright long lasting fluorescent lamp provides general area lighting. A three-
position slide switch turns the fluorescent light on and off. This switch also turns a three-
LED emergency flasher on and off.
The main quartz-halogen spotlight is controlled on and off by a latching trigger switch
on the handle.
The lantern light is powered by either the 12 volt battery pack or the 12 volt DC power
adapter.
A 12 volt DC accessory socket is located on the side of the unit. This permits cell phone
recharging or operating other 12 volt DC appliances. If the battery pack is installed
(3 Amp hour 12 volt battery or 36 watt hours), appliance wattage should be limited
to prevent rapid battery rundown.
FIGURE 5
SPOTLIGHT
FLUORESCENT LAMP
SLIDE SWITCH
FLUORESCENT/OFF/
EMERGENCY FLASHER
SCREW
SPOTLIGHT TRIGGER SWITCH
(LATCHING)
EMERGENCY FLASHER
12V DC
ACCESSORY SOCKET
BATTERY PACK OR
DC POWER ADAPTER
LENS
REFLECTOR
SCREW HOLE
(SCREW REMOVED)
BULB
BEZEL
REMOVE LENS
VEC258 Manual 3/03.qxp 1/23/07 5:18 PM Page 9