Filter
Top Products
4-18
Setting the Stud Welder Pistol
R
4.2 Installing the stud holder in the Stud Welding Pistol
The following diagram shows how the stud holder is installed in the Stud
Welding Pistols PS-1 and PS-3K. The Stud Welding Pistols PS-0K and PS-1K
are equipped with a support tube instead of the pistol feet (1).
1 Pistol foot 4 Bellows
2 Stud holder 5 Spring shaft
3 Union nut 6 Stud flange
• Loosen union nut (3) on Stud Welding Pistols PS-1 and PS-3K using the
socket spanner SW 17; for Stud Welding Pistols PS-0K and PS-1K socket
spanner SW 14 is required.
• Push stud holder (2) into the spring shaft (5) until it stops.
• Fix stud holder (2) into position with union nut (3).
NOTE
The stud flange must project over the pistol feet tips and the support tube
by the dimension of the flange thickness. If necessary, remove stud holder
and correct projection by adjusting the stop screw.
1
6
23 5
SZ05.0693.010.X
4