Filter
Top Products
7
CONNECTING THE CHARGER WITH THE DC ACCESSOR
Y PLUG
The charger’s output leads also contain a DC acces-
sory plug (Figure 5).
1. Plug DC plug into vehicle’s DC accessory outlet.
2. Plug the AC plug of the charger into any stan-
dard 110/120 volt AC wall outlet.
NOTE: The 12 volt DC recharging procedure is rec-
ommended only when it is necessary, as con-
tinued use of the 12 volt DC recharging pro-
cedure may shorten the battery system’s life .
If unit is fully discharged, it is recommended that the vehicle being used for recharging be
left running while the unit is being charged via the 12 volt DC method.
MAINTENANCE
With proper care and minimal maintenance, the Vector® Battery Charger will pro-
vide years of dependable service. For maximum performance, Vector® recommends:
1. Storing the unit in a clean, dry, cool place when not in use.
2. Cleaning the unit casing and cords (as necessary) with a dry (or slightly damp)
cloth. Ensure that unit is completely disconnected from battery and power
source, before cleaning.
3. To maintain the operating condition and maximize the life of the charger cords,
always coil them loosely for storage. Do not wrap them around the unit or crimp
them with a tight band.
SPECIFICATIONS
Input:...............................................120V AC 0.5 amps
Output:............................................Nominal 12 volt DC at up to 2 amperes
Reverse Polarity Protection ................Output battery clips short circuit protection
Bulk Charge.....................................2 amps constant current raises battery voltage
until it reaches 14.4V +/- 0.2V
Absorption.......................................Constant- holds voltage 14.4V +/- 0.2V and
forces the current to fully charge the battery
Float................................................When battery falls below 12.8V +/- 0.2V the
charger will start charging from Bulk Charge
stage again.
FIGURE 5. DC Accessory Plug