Filter
Top Products
Impact Wrench Kit by Wagan Tech
USER’S MANUAL — Please read before using this equipment.
________________________________________________________________________________________________________________________________________________________________
www.wagan.com
© 2004 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
3
- Avoid eye injuries. Always wear ANSI approved safety impact eye
goggles when working with a vehicle battery that under certain
circumstances can explode, causing possible serious burns and
injuries to the eyes.
- Avoid contact with battery acid. If splashed, immediately wash
affected area with clean water. Continue washing until medical help
is available.
- Avoid working alone. If an accident occurs, an assistant can bring
help.
- When using a power hand tool, always grasp the tool firmly with
both hands to maintain control of the tool.
- People with pacemakers should consult their physician(s) before
using this product. Operation of electrical tools in close proximity to a
heart pacemaker could cause interference or failure of the
pacemaker.
- The warnings, precautions, and instructions discussed in this
manual cannot cover all possible conditions and situations that may
occur. The operator must understand that common sense and
caution are factors, which cannot be built into this product, but must
be supplied by the operator.
If the vehicle’s cigarette lighter fuse is below 15 amps, you will need to use
the vehicle’s battery as an electric power source, using the Battery Clamps.
To do so attach the Red positive (+) Clamp to the positive (+) terminal on
the vehicle’s battery. Then, attach the Black negative (-) Clamp to the
negative (-) terminal on the vehicle’s battery then connect the Lead Wire
Plug to the Battery Clamps.
UNPACKING :
If any parts are missing or broken, please contact the store where it
is being purchased.
Note that this 12-volt Impact Wrench operates differently than 115
volt or air impact wrenches. The motor will run to build inertia, and
then will strike a blow of the hammer. This is repeated, becoming
more rapid with decreased resistance. This is normal operation for
this product.
OPERATING INSTRUCTIONS :
NOTE :
1. Make sure the vehicle is parked safely away from all other moving
traffic. Park the vehicle on a dry, flat, level, ground surface. Turn off the
vehicle, and set the vehicle’s emergency brake.
2. Select the appropriate size Socket with which to remove the Lug Nuts
on the vehicle’s wheel. Then, attach the Socket to the Impact Wrench.
4. If the vehicle’s cigarette lighter fuse is above 15 amps, you may use the
vehicle’s cigarette lighter receptacle as an electric power source. To do so,
remove the cigarette lighter and insert the Lead Wire Plug firmly into the
cigarette lighter receptacle.