Wagner SprayTech 1150 Paint Sprayer User Manual


 
7
SPECIFICATIONS
MODEL EP2300
1. GPM----------------------------------------------------------2/3
2. Maximum pressure------------------------------- 3000 PSI
3. Motor - electric ------------------------------------------1 HP
4. Amperage-------------------------------------------8.5 Amps
5. Cycle------------------------------------124 cycles per min.
6. Maximum Tip Size @2000 psi---------------------- .023"
(Latex paint)
1. Attach handle to cart using bolts and knobs provided.
Insert bolt through square hole in handle and then
through hole in cart leg. Secure with knob. Repeat
other side.
2. Remove protector cap on outlet fitting and install air-
less hose. DO NOT INSTALL SPRAY TIP(S) IN GUN(S)
AT THIS POINT.
INITIAL SET-UP
The SprayTech EP2300 Piston Pump unit is fully assembled upon delivery. Follow these
simple steps for set-up:
CART MOUNT/LOW BOY
LOWBOY
1. Remove the plug from the inlet elbow on the fluid
section.
2. Attach the suction set fitting into the inlet elbow on the
fluid section.
3. Attach the return line to the tube fitting at the dump
valve.
4. Remove protector cap on outlet fitting and install air-
less hose. DO NOT INSTALL SPRAY TIP(S) IN
GUN(S) AT THIS POINT.
SprayTech EP2300 Low Boy Piston Pump
Figure 1. SprayTech EP2300 Cart Mounted Piston Pump
7. Max. Hose Length @ 2000 PSI-----------------100 feet
8. Weight:
LowBoy--------------------------------------------------63 lbs.
Cart Mount--------------------------------------------- 64 lbs.
9. Dimensions:
Cart Mount -------------------------------30"Lx39''Hx21''W
LowBoy------------------------------------28L x 21H x 21W
(38H with Handle)
Figure 2. Install Siphon Tube