Wagner SprayTech 1150 Paint Sprayer User Manual


 
10
1. Engage the gun safety latch.
2. Shut off the motor and turn the pressure control knob
counterclockwise as far as possible.
3. Turn the prime/spray ball valve to prime, having a pail
ready to catch the drainage or return to the paint
container via the return hose.
4. Disengage the gun safety latch.
5. Hold metal part of the gun firmly to the side of a metal
pail to avoid a build up of static electricity, and trigger
the gun into the metal container to relieve the pressure.
6. Engage the gun safety latch.
7. Leave the prime/spray ball valve on prime, until you are
ready to operate the sprayer again.
WARNING
the unit down for any purpose, including servicing or
adjusting any part of the spray system, changing or
cleaning spray tips, or preparing for clean-up.
Be sure to follow the Pressure
Relief Procedure when shutting
Using the Spray Gun
NOTE: FOLLOW THE INSTRUCTIONS THAT CAME
WITH YOUR GUN.
PRESSURE RELIEF PROCEDURE
Prime the Sprayer with Paint
1. Turn the prime/spray ball valve to prime.
2. Put the suction tube into the paint container.
3. Turn the pressure control knob counterclockwise as far
as possible to the lowest pressure setting.
4. Start motor. Slowly increase pressure by turning the
pressure control knob clockwise until pump begins to
function. When paint begins to flow through return tube
decrease pressure by turning the pressure control
knob counterclockwise and then turn the prime/spray
ball valve to the spray position.
5. Disengage the gun safety latch.
6. Hold a metal part of the gun firmly against and aimed
into a metal waste container. Trigger the gun and hold
it open while slowly increasing the pressure setting by
turning the pressure control knob clockwise until the
sprayer starts. Keep the gun triggered until all the air
is forced out of the system and paint is flowing freely.
Release the trigger and engage the safety latch.
7. Check all fluid connections for leaks. If any are found,
follow the pressure relief procedure before tightening
the connection.