Filter
Top Products
Grounding Instructions
This product must be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock by
providing an escape wire for the electric current. This product
is equipped with a cord having a grounding wire with an
appropriate grounding plug. The plug must be plugged into an
outlet that is installed properly and grounded in accordance
with all local codes and ordinances.
Improper installation of the grounding plug can result in a
risk of electric shock.
If repair or replacement of the cord or plug is necessary, do not
connect the green grounding wire to either flat blade terminal.
The wire with insulation having an outer surface that is green,
with or without yellow stripes, is the grounding wire and must
be connected to grounding pin.
Check with a qualified electrician or serviceman if the
grounding instructions are not completely understood, or if in
doubt as to whether the product is grounded properly. Do not
modify the plug provided; if it will not fit the outlet, have the
proper outlet installed by a qualified electrician.
This product is for use on a nominal 120 volt circuit, and has a
grounding plug that looks like the plug illustrated in sketch A.
A temporary adapter that looks like the adapter illustrated in
sketch B and C may be used to connect this plug to a 2 pole
receptacle as shown in sketch B if a properly grounded outlet
is not available. The temporary adapter should be used only
until a properly grounded outlet (sketch A) can be installed by
a qualified electrician. The green colored rigid ear lug, or the
like extending from the adapter must be connected to a
permanent ground such as a properly grounded outlet box
cover. Whenever the adapter is used, it must be held in place
by a metal screw.
Service
Should your spray system need service during the warranty
period, return your unit and the proof of purchase to the
distributor where it was purchased. At our option, the unit will
be repaired or replaced. In a continued commitment to
improve quality, we reserve the right to make component or
design changes when necessary.
(A) (C)(B)
WARNING
Introduction
This High Volume/Low Pressure (HVLP) spray system is
designed for applying coatings to surfaces that can be sprayed
faster than brushing or rolling and are too small for traditional
airless sprayers. Components of this system include a power
switch, a power cord, a replaceable fuse, a dual filtration
system, a cup holder, an air hose, and an air outlet.
With this HVLP spray system, you can achieve the highest
quality professional finish possible with little or no preparation
or setup time. Please review all the information contained in
this manual before operating the system.
Using an HVLP Spray System
Refer to the following information to operate and understand
your HVLP spray system.
Setup
Use the following procedure to set up your HVLP spray system
for operation.
1. Plug the turbine power cord into a grounded, 3-slot
receptacle.
Keep the turbine at the maximum possible distance from
the spray area to safeguard against explosion or fire that
may be caused by sparking electrical parts.
2. Prepare your spray gun for operation. Refer to your spray
gun manual for material preparation, setup, and spraying
information.
3. Attach the air hose to the air outlet on the turbine.
4. Attach the air hose to the air inlet on your spray gun.
5. Turn on the turbine and begin spraying.
WARNING
Air Outlet
Cup Holder
Fuse
Filter (in end
of filter can)
Power Cord
Power Switch
Filter
Air Hose
© 1999 SprayTECH Corporation. All rights reserved. 3
English