Filter
Top Products
Grounding Instructions
This product must be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock by
providing an escape wire for the electric current. This product
is equipped with a cord having a grounding wire with an
appropriate grounding plug. The plug must be plugged into an
outlet that is installed properly and grounded in accordance
with all local codes and ordinances.
Improper installation of the grounding plug can result in a
risk of electric shock.
Service
Should your spray system need service during the warranty
period, return your unit and the proof of purchase to the
distributor where it was purchased. At our option, the unit will
be repaired or replaced. In a continued commitment to
improve quality, we reserve the right to make component or
design changes when necessary.
WARNING
Introduction
This High Volume/Low Pressure (HVLP) spray system is
designed for applying coatings to surfaces that can be sprayed
faster than brushing or rolling and are too small for traditional
airless sprayers. Components of this system include a power
switch, a power cord, a filter warning light, a replaceable fuse,
a dual filtration system, a cup holder, an air hose, and an air
outlet.
With this HVLP spray system, you can achieve the highest
quality professional finish possible with little or no preparation
or setup time. Please review all the information contained in
this manual before operating the system.
Using an HVLP Spray System
Refer to the following information to operate and understand
your HVLP spray system.
Setup
Use the following procedure to set up your HVLP spray system
for operation.
1. Plug the turbine power cord into a grounded, 3-slot
receptacle.
Keep the turbine at the maximum possible distance from
the spray area to safeguard against explosion or fire that
may be caused by sparking electrical parts.
2. Prepare your spray gun for operation. Refer to your spray
gun manual for material preparation, setup, and spraying
information.
3. Attach the air hose to the air outlet on the turbine.
4. Attach the air hose to the air inlet on your spray gun.
5. Turn on the turbine and begin spraying.
WARNING
Cup Holder
Fuse
Filter
Warning
Light
Power Switch
Filter
Filter (in end
of filter can)
Air Hose
Air Outlet
© 1998 Wagner Spray Tech Corporation. All rights reserved. 3
English
R