Filter
Top Products
8 ProSpray 3.23
GB
Description of unit Starting operation
3.5 Technical data
Voltage: 100-110Volt,50/60Hz
Max. current consumption: 11 A
Power cord: 3 x 1.5 mm
2
– 6 m or 2.5 m
Acceptance capacity: 1035 Watt
Max. operating pressure: 221 bar (22.1 MPa)
Volume ow at 12 MPa
(120 bar) with water: 2.3 l/min
Max tip size: 0.024 inch – 0.61 mm
Max. temperature of the
coating material: 43°C
Max viscosity: 20.000 mPa·s
Weight: 17.7 kg
Special high-pressure hose: DN 6 mm, 15 m, connection
thread M 16 x 1.5
Dimensions (L X W X H): 436 x 369 x 416 mm
Max sound pressure level: 80 dB (A) *
* Placeofmeasuring:1mindistancefromtheunitand1.6
m above the oor, 12 MPa (120 bar) operating pressure,
reverberant oor.
3.6 Transportation in vehicle
Secure the unit with a suitable fastening.
4. Starting operation
4.1 High-pressure hose, spray gun and separating
oil
1. Screw the pressure gauge (1) to the coating material outlet
(Fig. 2, Item 2).
2. Screw the high-pressure hose (3) to the coating material
outlet on the pressure gauge (Fig. 2, Item 4).
3. Screw the spray gun (5) with the selected tip onto the high-
pressure hose.
4. Tighten the union nuts at the high-pressure hoses rmly so
that coating material does not leak.
5
1
4
2
3
5. Remove the oil cup cap with a straight-slot screwdriver.
6. Fill the oil cup with EasyGlide (Fig. 3) until the oil gauge (6) is
showing that it is full.
Attention
EasyGlide prevents increased wear and tear to the
packings.
7. Replace oil cup cap.
8. Press oil button 2-5 times to prime the oiler. Press once for
every eight hours of usage to lubricate the uid section.
9. Fully depress the pusher stem to make sure the inlet ball is
free.