Filter
Top Products
13
English
Call 1-800-880-0993 if you have any problems or questions regarding the cleaning of your sprayer.
• When using latex materials, clean your sprayer and
components with water. When using oil-based materials,
use mineral spirits.
• Do not use mineral spirits on latex materials, or the
mixture will turn into a jelly-like substance which is
difficult to remove.
• No matter which cleaning solution you use, make sure to
d
ispose of it properly when finished cleaning your sprayer.
• Thorough cleaning and lubrication of the sprayer is the
most important step you can take to ensure proper
operation after storage.
Important Cleaning Notes!
Read these notes and warnings before you start to clean your sprayer!
S
pecial cleaning instructions for use with flammable solvents:
•
ALWAYS FLUSH SPRAY GUN AT LEAST ONE HOSE
L
ENGTH AWAY FROM SPRAY PUMP.
• If collecting flushed solvents in one gallon metal
container, place it into an empty five gallon container,
then flush.
• Area must be free from vapors.
• Follow all cleanup instructions.
• DO NOT USE GASOLINE TO CLEAN YOUR SPRAYER.
WARNING
1. Lock the gun and remove the spray tip assembly. Place
the suction tube and return tube into an empty waste
container.
Cleanup - Latex materials
Follow these steps if you used latex materials AND if you have a garden hose available. If you do not have a garden
hose available, follow the Cleanup - Oil-Based Materials instructions.
2. Using a garden hose, rinse off the suction tube, return
tube and inlet filter. Empty the waste container.
3. Remove the inlet filter from the suction tube and place
into the waste container.
4. Verify that the seal is
present inside the
adapter
(a) Thread the
pump cleaning adapter
(b) onto a garden hose
(c). Connect hose and
adapter to the fitting on
the end of the suction
tube
(d).
Continued on next page.
Empty waste
container
(b)
(c)
(d)
(a)