English
8
2. Load
Material
Start
You will need:
• The material you plan to spray
• Flat blade screwdriver
• Piston Oil™
• Waste bucket
1. Remove AutoOiler cap with a
at blade screwdriver.
Squirt Piston Oil into the
AutoOiler. Replace cap.
2. Push AutoOiler button 2-5 times
to lubricate the uid section.
Press button 2-3 times before
every use. Be sure to check
reservoir level (a) and rell as
necessary.
5. Turn the PRIME/SPRAY
knob to PRIME.
4. Place a full container
of spraying material
underneath the suction
tube (a).
Hold the return tube into a
waste container (b).
6. Attach the supplied
grounding wire to a
grounded object.
Start the engine (see
directions on page 4).
7. Increase the pressure to
maximum (+).
Allow pump to run until
you see spray material
owingfromthereturn
tube.
8. Shut the engine off. Place
return tube back into
material container and clip
return tube and suction tube
together.
3. Fully depress the Sureo valve
to make sure the inlet ball is
free.
(a)
1 2 3
SPRAY
PRIME
54
6 7
8
(a)
(b)