Filter
Top Products
11
use of water greatly decreases the amount of dust produced during the
cutting process, aids in the cooling of the blade, and provides additional
stability.
• Use Only Water In The Water Tank
• Do Not Drink From The Tank
D. Operating the Saw
1. For blade installation instructions see section II. Operation sub heading A.
Installing the Blade. For the engine starting instructions, see the Engine
manual and follow the instructions located in section II. Operation sub
heading B. Starting the Engine.
2. Check the Engine Oil level.
3. Raise the saw to the full upright position. Do not let the blade come in
contact with the ground.
4. Maneuver the saw to the desired starting point.
5. If wet cutting, connect the water supply to the saw.
6. Follow the instructions for starting the engine found in the Engine manual.
7. If wet cutting, turn on the water supply at the source and then open the
water valves on the saw. Make sure that there is a minimum of 4-6 gallons
per minute of water flow!!
8. Be sure the engine is running at full throttle!!!
9. Slowly lower the blade by rotating the hand wheel clockwise until the
desired depth of cut is reached. Use a reasonable rate of feed. Do not
force the blade into the cut!!
10. When the end of the cut is reached, slowly raise the blade out of the cut
by rotating the Hand Wheel counter-clockwise until the blade is at least
one (1) inch above the ground.
11. Only move the saw in reverse with the blade in the raised position.