Wolfcraft 3408 Drill User Manual


 
DRILL MOUNTING
Tools Required
• Flat blade Screwdriver
Standard Mounting
See Figure 6 for reference.
1. Adjust the quick-release clamp so
that it is in the wide open position.
2. Open the chuck on the drill to its
widest position.
3. Insert the drill through the quick-
release clamp and onto the shaft.
Tighten the drill chuck.
4. Loosen the knob at the top of the
adjustment bracket.
5. Move the adjustment bracket so that
it is in contact with the drill. Tighten
the knob on the adjustment bracket
securely.
6. Secure the drill to the adjustment
bracket by tightening the quick-
release clamp. Make sure the drill
vent slots remain uncovered to
provide proper cooling for the drill
motor.
7. Route cord through the mount
located on the head assembly. See
Figure 6 inset.
Figure 6
9
Drill Chuck "L"
Adapter Bracket
Depth
Adjustment
Assembly
Adjustment
Handle
Quick-Release
Clamp
Handle
Handle Screw
Adjustment
Bracket
Adjustment
Knob
Chuck Key
Storage Hole
Detail of Cord Mount
Base
Mounting
Holes
Base
Bolt
Post
Chuck