Filter
Top Products
Owner Service 11
MAN0357 (Rev. 12/10/2007)
Figure 2
4. Remove the shaft nut (13, using part number
1023106 socket), the shaft washer, and the
tongued washer (27), Figure 3.
Figure 3
5. Pull the inner bearing housing (9) from the shaft,
Figure 4.
Figure 4
6. Remove the outer bearing housing mounting
hardware (55 & 57). See page 16.
7. Slide the outer bearing housing (28) out of the
drum. If needed, use threaded holes (1/2" UNC) in
the housing to unseat it from the drum weldment,
Figure 5.
8. Remove the outer bearing housing mounting
hardware on the motor end.
9. Slide the bearing housing assembly and the shaft
out of the drum.
Figure 5
10. Repeat steps 3 through 5 on the motor end.
11. Slide the outer bearing housing off the shaft.
NOTICE
■ Removal of the bearing housing will cause the
shaft to fall. Shaft and bearing housings are heavy.
Be careful not to drop one on the other as denting
may occur.
INNER BEARING REPLACEMENT
1. Remove the bearing seal (10) from the end of the
inner bearing housing. See page 16.
2. Tilt the housing to allow each bearing cone (12) to
fall out.
3. Bearing cups (11) must be removed and replaced
using an industrial press.
4. Replace bearing cones.
5. Press a new bearing seal into the end of the
housing.
NOTE: The isolators (36) may need to be removed
in order to press the seal into the housing properly.
OUTER BEARING REPLACEMENT
1. Press out the ball bearing set (29) from the
housing. See page 16.
2. Replace the bearing set and press into housing
using an industrial press.
14
13
27
9