Filter
Top Products
UMAN-Charge 16
Charging
Tr ic kle
Charging
Temperature
too high/low
UCN72 Wall Charger
Description
The UCN72 is a wall mounted fast charger with universal
110 to 230, 50-60 Hz. VAC input. Multiple A.C. plug configu-
rations comply with most interna-
tional standards. This charger is
used with the Encore and Cameo
series printers equipped with
NiMH batteries. The UCN72 will
charge a battery pack as fast as its
charge level will allow, and then
switch over to a trickle mode to
maintain the charge at its maxi-
mum. Refer to the table below for
part numbers.
Charging Battery Packs
Plug the UCN72 into the appro-
priate A.C. wall receptacle, then
insert the charge cable into the
battery pack charger jack.
The charger LED will indicate the status of the
charger as follows:
• A steady light indicates the battery pack is
undergoing a fast charge.
• A slow blinking light indicates the charger is
in trickle mode. The battery pack is ready for
use.
• A rapidly blinking light indicates a problem
with the battery pack. The battery may have an
internal short, or its charge monitoring circuitry
may be malfunctioning. The battery pack
should not be used any further.
Do not attempt to charge batteries with the UCN72
while printing. Attempting to print while charging can result in
improperly charged batteries.
Charge indicator