Filter
Top Products
GB-11
G
B
SGCZ2600DL/SGCZ2600DW
8. Operation
(DW)
While holding the unit by your left
hand securely, press the red button
of the buckle.
Then take the harness off from your
shoulders.
(1) Buckle
USAGE
This machine does cutting not by a rotary cutter like con-
ventional trimmers but by a pair of special blades, each
upper blade and lower blade oscillate opposite direc-
tion alternately within a limited angle at a speed of ap-
proximately 1/30 of conventional trimmers.
This unique mechanism brings you many benefits like
the following:
1. Since the blade does not cause grass chips and
pebbles to the thrown around, you may use less care
about your clothing or surroundings.
2. Should the blade hit a rigid object like stones, trees
or steel poles during operation, it does not produce a
bounce motion that can cause loss of machine con-
trol.
3. Since the blade does not cause cut grass to wrap
around the neck, you need not to stop operation to
remove such wrappers.
What's more, since the whole circle of the blade is avail-
able for cutting, you can move the cutting head in all di-
rections and cut grass growing on such place difficult-to-
get with conventional trimmer.
You can even trim the waterside without splashing water.
HOW TO USE
•
Adjust the front handle to the most comfortable position.
•
Start the engine and pull the throttle trigger gradually. The
blades will start moving as the engine speed goes up.
•To stop the blade motion, simply release the throttle
trigger. The clutch will disengage and the blades stop
moving while the engine keeps idling.
• Move the cutting head as sliding its bottom on the
ground. This will help you do the job with less effort.
NOTE
a) Avoid running the engine at full throttle with no load.
Continuous no load full throttle operation can cause
damage to the engine and the drive shaft.
b) Operation at too slow engine speed can cause ab-
normal vibration of the machine, resulting in short life
of drive shaft and clutch parts. If you felt such vibra-
tion, use a higher speed range.
c) Though the blades are made of steel harder than con-
ventional metal blades, continuous cutting in soil will
accelerate wear.
HARNESS
WARNING
ALWAYS WEAR THE PROVIDED HARNESS WHEN
USING THE MACHINE!
Always make sure the machine is hooked securely
to the harness.
If you don't, you will be unable to control the machine
safely. This can result in injury to yourself or others.
Never use a harness with a defective quick release
or any other damage.
HOW TO WEAR
1. Wear the provided harness without twisted bands, with
the hanger on your right side.
(1) Hanger
BALANCE THE UNIT
1. Hook your machine to the hanger.
2. Adjust the bands of the harness to have the blade
parallel to the ground when standing in your normal
working position to provide you most effectiveness
and comfort on operating the machine.
3. In order to prevent the hanger position to change
during operation, turn up the extra part of the band
from the buckle.
4. When correctly adjusted, check the correct working
of the harnesses' QUICK RELEASE.
QUICK RELEASE
The harness is equipped with a "QUICK RELEASE"devise.
To release the machine from the harness in emergency
situations, please follow the procedure as explained
below.
WARNING
Make sure to check proper working of the QUICK RE-
LEASE device BEFORE operating the machine.
Make sure to hold the unit securely when using the
QUICK RELEASE.
(DL)
While holding the unit by your
right hand securely, press both
sides of the
buckle. sides of the buckle.
(1) Buckle
(DL: Single strap)
(DW: Double strap)
(1)
(1)
(1)
(1)
(DW: Double strap)
(DL: Single strap)