Hardware Installation 2-9
Figure 2-4 AccessBuilder Ethernet AUI LAN Connection
Token Ring
1 Set the Token Ring 4M/16M speed switch to the appropriate ring speed
and attach the AccessBuilder to your ring.
2 Install and connect your serial card (or cards) to your modems,
CSU/DSU, ISDN line, etc. Refer to Appendix C for details.
Power Up If you plan to use TABM to manage the AccessBuilder over an IP
network, be sure the TABM software has been installed and launched
on your management workstation before you power up the
AccessBuilder 4000. Otherwise the BootP requests (for assigning an IP
address) issued by the newly installed AccessBuilder will not be “heard”
by TABM.
Proceed to Chapter 3 to install the TABM software on your Windows
workstation. Once TABM has been installed and launched, newly
installed AccessBuilders on the network will be identified by the
TABMTOOL utility (IP only).
110-240 VAC
50-60 Hz 1A
UTP
CONSOLE
BNC
BNC/AUI/TPE
ETHERNET
AUI
SLOT 2
SLOT 1
AUI Connection
ab4kbook Page 9 Thursday, March 27, 1997 11:51 AM
