12
Equipment Setup
DANGER
This equipment contains high voltage. Risk of electric shock. Do
not remove protective panels. Serviceable only by certified 3M
technicians. No user-serviceable parts.
NOTE: If the Mediacheck Model 325 is part of a
SelfCheck System V-Series installation, setup is
provided by a 3M technician.
1 Flip the power selection switch to the supply
voltage used by your library.
NOTE: In the U.S. and Canada, use the 115 V.
setting. The factory sets this switch to
230 V.
Keep all audiocassettes out of the Mediacheck.
2 Connect the power cord to the back of the
Mediacheck.
3 Plug the other end of the power cord into a power
outlet.
The Mediacheck is designed to be left ON
continuously.
After power is connected, the unit runs a
diagnostic self-test.
After a successful diagnostic self-test, the
Mediacheck automatically switches to Check-in
mode. The Check-in button light (located on the
front panel) will be ON
325_OM_Volta
e_switch
Power Selection Switch
Figure 3: Power selection switch settings.
