4
Cut from top to bottom all four corners of the carton •
and lay panels at. See gure 1.
Remove the lag screw that holds the oating hitch to •
the packing skid.
Disassemble and discard carton's wood top and side •
supports.
Remove four hex bolt, hex nuts and at washer from •
the hold down brackets at the rear of the carton.
Remove and save the two Flat Washers and Cotter Pins •
from rear axle. Reuse when attaching gauge wheels.
Discard all other packing hardware and hold down •
brackets.
ASSEMBLY
TO iNSTALL ThE TiLLER GAUGE WhEELS
Assemble Gauge Wheels onto the Rear Axle with •
the extended end of Hub facing inward. Secure with
the Flat Washers and Cotter Pins which you removed
from the axle during unpacking. See gure 2.
TO iNSTALL ThE TiLLER TiNE ASSEMBLiES
Attach the oating hitch to the tractor's draw bar. •
Refer to on page 6.
Remove the preassembled 3/8" x 2" hex bolt and 3/8" •
nylock nut from the L.H. Tine Assembly. Slide the tine
assembly onto the Transmission Axle on the left side
of the tiller and secure with the hex bolt and nylock
nut. See gure 3. Repeat for the R.H. side.
Weights are not furnished with Tiller. 30 lb. tractor
wheel weights may be purchased to mount to Tiller if
extra weight is required. (Refer to section.)
Remove two Hex Bolts and Nuts from each Tine •
Shield, located approximately 3-1/2" from front edge.
See gure 4.
Place (Wheel) Weights on Tine Shield and secure •
with long Bolts and Nuts furnished with Weights. See
gure 4.
FiGURE 1
FiGURE 2
FiGURE 3
FiGURE 4
