Specifications:
Rivet Capacity: 3/16”
Overall Length: 10-5/8”(270mm)
Net Weight: 3lbs(1.41kg)
Stroke: 1/2”(14mm)
Motor: 1/2hp
Air Inlet Thread NPT: 1/4”
Air Hose I.D. Size: 3/8”(10mm)
Avg. Air Consumption: 4cfm
Air Pressure: 90-120psi
Maintenance/Adding Oil for Hydraulic Riveter
1. Turn off air supply
2. Use spanner wrench to dismantle the riveter head (fig. 1).
3. Use spanner wrench to open bottom cover of the riveter (fig. 2).
4. Remove piston from cylinder (fig. 3).
5. Clean inside of the cylinder and lubricate cover seal (fig. 4).
6. Lubricate the intake with oil until full (fig. 5).
7. Clean piston stem and add grease on the inner wall of the cylinder and the ring.
8. Reassemble (fig.6).
Cleaning/Maintenance for the Head of Riveter
1. Turn off air supply. Assure all pressure is released prior to disassembly.
2. Use spanner wrench to dismantle the riveter head (fig.1).
3. Use spanner wrench to disassemble (fig. 2).
4. Clean all inner/assembly parts of the riveter head with a brush.
5. Reassemble the inner/assembly parts.
6. Oil the parts and reassemble riveter head completely.
