Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435
©2006 ATLAS SOUND LP Printed in U.S.A. ATS002455 RevB 11/06 PP
INSTALLATION INSTRUCTIONS
AH SERIES 15" WOOFER
10
SPECIFICATIONS
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE REMEDY
Call Atlas Sound tech support at 1-800-876-3333 with any additional questions.
MODEL POWER
RATING
RMS
FREQUENCY
RES. ±5dB
SOUND LEVEL DISPERSION IMPEDANCE DIMENSIONS WEIGHT
RP/1M 1W/1M
AHSUB15S 250 Watts RMS 55Hz to 120Hz 127dB 103dB Omni 8 Ohms 30.56"H (776mm)
30"W (762mm)
28.1"D (714mm)
181 lbs (82.1kg)
There is no sound Power off. Equipment setting is wrong.
Volume set too low.
Assure that power is applied to all equipment in system. Check
that routing (input/output) controls are set correctly. Check that
volume level is above minimum.
Loose connection. Check system from start to finish for crossed wires, loose
connection, etc. On the AH location check for correct connection.
Low sound level Setting/volume control is set too low.
Connection is shorted or bad.
Check volume levels or amplifiers and related equipment
(equalizer). Check that connections aren't partially shorted/
corroded.
Sound cuts in and out System overload/oscillation intermittent connection. Check for overload condition or bad connection.
Distortion at increased levels Amplifier/speaker overdriven. Check that power to speaker isn't over limits. Check that amplifier
isn't overdriven. Reduce power to amplifier slightly.
Speaker makes "buzzing" noise Hardware loose or speaker damaged. Make sure speaker grille is tight. Check other hardware
connections. Check speakers for loose parts or speaker damage.
